Installing Exchange Transmission

Caution:
After 2000 km it is absolutely essential to carry out a breaking-in inspection including an oil change.
The transmission must be filled with Lifetime oil.

Remove transmission, refer to Removing and Installing Transmission.
Fit following parts from old transmission on the new transmission:
Release bearing and release lever, refer to Clutch M/T, Throw-out Fork.
Dowel pin for slave cylinder
Reverse light switch
Retainers for oxygen sensor cable
Transmission breather cap (refer to sticker on transmission)





Transfer shift-rod joint.
Slide back retaining ring (1) and drive out cylindrical pin (2).





Note: Check damping disk (6) for damage and replace if necessary.