Oil Pan: Service and Repair

Removal Procedure

Notice: Remove the oil level sensor, located in the oil pan, before the oil pan is removed. The sensor may be damaged if the oil pan is removed first.

1. Raise the vehicle.
2. Drain the engine oil.
3. Remove the flywheel cover.





4. Remove the oil level sensor.
5. Remove the oil filter.





6. Remove the oil pan.
7. Remove the oil pump pipe and screen.
8. Remove the oil pan gasket.
9. Clean the oil pan and cylinder block mating surfaces.

Installation Procedure

Notice: Install the oil level sensor, located in the oil pan, after the oil pan is installed. The sensor may be damaged if the oil level sensor is installed first.

1. Install the oil pan gasket.
2. Install the oil pump pipe and screen.

Notice: Refer to Fastener Notice in Service Precautions.





3. Install the oil pan.

Important: Do not over tighten the oil pan bolts or damage to the oil pan could occur.

4. Install the oil pan bolts.
- Tighten the oil pan bolts to 14 Nm (125 inch lbs.).
5. Install the oil filter.
6. Install the flywheel cover.





7. Install the oil level sensor.
8. Lower the vehicle.
9. Refill the engine oil.