Turn Lamps

With the ignition switch in the RUN position, battery positive voltage (B+) is supplied from the IP fuse block T/SIG/BU LP/BTSI fuse 1B via CKT 539 (PNK) through the turn signal flasher to the normally closed switch in the turn/hazard switch via CKT 16 (PPL). With the turn switch in the left turn position, battery positive voltage (B+) is applied through the turn switch and two paths to the turn lamps. One path is to the left front park/turn lamps and the side marker lamps via CKT 14 (LT BLU). The second path is supplied to the left tail/stop/turn lamps via CKT 18 (YEL).

The lamps go on immediately. The lights begin to flash when the current heats up the timing element in the flasher, and the flasher repeatedly opens and closes the circuit. A similar procedure is followed when the turn switch is in the right turn position. Battery positive voltage (B+) is supplied to the right front park/turn lamps and the side marker lamps via CKT 15 (DK BLU). Battery positive voltage (B+) is supplied to the right tail/stop/turn lamps via CKT 19 (DK GRN).