Accelerator Controls Cable Bracket Replacement

REMOVAL PROCEDURE




1. Remove the fuel injector sight shield.




2. Rotate the throttle lever.
3. Remove the cruise control cable (1) from the accelerator controls cable bracket (2).




4. Disconnect the accelerator controls cable (2) from the accelerator controls cable bracket (1).




5. Remove the wiring harness clip (1) from accelerator controls cable bracket (3).




6. Remove the two bolts from the accelerator controls cable bracket.

INSTALLATION PROCEDURE





NOTE:
^ Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be securely fastened. This is necessary in order to prevent possible interference and damage to the component.
^ Refer to Fastener Notice in Service Precautions.

1. Install the two bolts to the accelerator controls cable bracket.

Tighten
Tighten the bolts to 16 N.m (12 lb ft).




2. Install the wiring harness clip (1) to the accelerator controls cable bracket (3).




3. Install the accelerator controls cable (2) to the accelerator controls cable bracket (1).




4. Install the cruise control cable (1) to the accelerator controls cable bracket (2).





IMPORTANT: The throttle should operate freely, without binding, between full closed and wide open throttle.

5. Check for complete throttle opening and closing positions by operating the accelerator controls pedal. Also check for poor carpet fit under the accelerator controls pedal.
6. Install the fuel injector sight shield.