Adjustment Link Replacement

REMOVAL PROCEDURE

- Tools Required
- J 24319-01 Universal Steering Linkage Puller





1. Remove the wheel and tire.
2. Remove the cotter pin (2) and slotted hex nut (1).





3. Using J 24319-B, separate the adjustment link from the knuckle.
4. Loosen the adjustment link retaining nut.
5. Remove the adjustment link.

INSTALLATION PROCEDURE

NOTICE: Refer to Fastener Notice in Service Precautions.





1. Install the adjustment link with retaining nut.
- Tighten the retaining nut to 85 Nm (63 ft. lbs.).

2. Install the link to the knuckle and position the boot toward the front of the vehicle.
3. Install the slotted hex nut.
- Tighten the nut to 45 Nm (33 ft. lbs.).

4. After tightening the slotted hex nut to specification, align the slot in the nut to cotter pin hole by tightening only, do not loosen the nut to align for the cotter pin (2).
5. Install the wheel and tire.
- Tighten the nut to 140 Nm (100 ft. lbs.).