Remote Control: Service and Repair

STEERING WHEEL CONTROL SWITCHES REPLACEMENT

REMOVAL PROCEDURE

CAUTION: Refer to SIR Caution in Service Precautions.




1. Disable the SIR system. Refer to Disabling the SIR System in Restraint Systems.
2. Remove the steering wheel.
3. Remove the steering wheel bezel fasteners (1).
4. Remove the steering wheel bezel (2).




5. Insert a small, blunt ended tool into the access hole in the back of the steering wheel in order to push the switch out of the steering wheel.
6. Disconnect the electrical connector.

INSTALLATION PROCEDURE




1. Connect the electrical connector.
2. Align the switch to the switch opening in the steering wheel.
3. Snap the switch into the steering wheel.




4. Install the steering wheel bezel (2).

NOTE: Refer to Fastener Notice in Service Precautions.

5. Install the steering wheel bezel fasteners (1).

Tighten
Tighten fasteners to 3 N.m (26 lb in).

6. Install the steering wheel.
7. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.