Instrument Panel (IP) - Accessory Trim Plate Replacement

Trim Plate Replacement - IP Accessory (Aztek)

Removal Procedure

1. Position the floor shifter in the Drive position.
2. Remove 2 screws from the lower trim plate.




3. Remove the instrument panel (IP) accessory trim plate by releasing the retainers.



Installation Procedure





1. Align the retainers on the IP accessory trim plate to the slots in the IP.
2. Install the retainers into the slots until the retainers are fully seated.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the 2 screws to the lower trim plate.

Tighten the screws to 2 N.m (18 lb in).