Accelerator Controls Cable Bracket Replacement

ACCELERATOR CONTROLS CABLE BRACKET REPLACEMENT

REMOVAL PROCEDURE
1. Remove the fuel injector sight shield.




2. Disconnect the cruise control cable (1) from the throttle lever.
3. Disconnect the cruise control cable (1) from the bracket (2).




4. Disconnect the accelerator cable (2) from the throttle lever.
5. Disconnect the accelerator cable (2) from the bracket (1).




6. Remove the wiring harness clip (1) from bracket (3) if necessary (VIN K only).




7. Remove the two bolts from the bracket.

INSTALLATION PROCEDURE

NOTE: Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be securely fastened. This is necessary in order to prevent possible interference and damage to the component.




1. Install the two brackets bolts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the bolts to 16 N.m (12 lb Ft).




2. Install wiring harness clip (1) from bracket (3) if necessary.




3. Install the accelerator cable (2) to the bracket (1).
4. Install the accelerator cable (2) to the throttle lever.




5. Install the cruise control cable (1) to the bracket (2).
6. Install the cruise control cable (1) to the throttle lever.
7. Check for complete throttle opening and closing positions by operating the accelerator pedal. Also check for poor carpet fit under the accelerator pedal.

IMPORTANT: The throttle should operate freely, without binding, between full closed and wide open throttle (WOT).

8. Install the fuel injection sight shield.