Ignition Coil(s) Replacement - Bank 1

IGNITION COIL(S) REPLACEMENT - BANK 1

REMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Disconnect the intermediate steering shaft from the steering gear.
4. Remove and reposition the front portion of the front fender liners in order to gain access to the frame front bolts.
5. Lower the vehicle.




6. Position a floor jack at the front center section of the frame in order to support the powertrain.
7. Remove the frame front bolts.
8. Carefully lower the powertrain in order to provide access.

IMPORTANT: Do not lower the powertrain more than 100 mm (4 in).

9. Reposition the evaporative emission (EVAP) purge hoses as necessary in order to provide access.




10. Disconnect the applicable ignition coil electrical connectors.




11. Remove the ignition coil bolts.
12. Remove the ignition coils.

INSTALLATION PROCEDURE




1. Install the ignition coils.
2. Install the ignition coil bolts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the ignition coil bolts to 10 N.m (89 lb in).




3. Connect the ignition coil electrical connectors.




4. Use the floor jack in order to raise the powertrain until the frame contacts the chassis.
5. Install the frame front bolts.
6. Raise and support the vehicle. Refer to Vehicle Lifting.
7. Install the front fender liners.
8. Connect the intermediate steering shaft to the steering gear.
9. Lower the vehicle.