Escalade EXT With Stabilitrak

The content of this article reflects the changes called out by TSB - 02-05-25-001.

Removal Procedure

1. Remove the passenger seat from the vehicle.
2. Pull the carpet back to gain access to the sensor.





3. Remove the nuts retaining the yaw rate sensor/lateral accelerometer (2) to the vehicle.





4. Disconnect the electrical connector from the yaw rate sensor/lateral accelerometer.
5. Remove the yaw rate sensor/lateral accelerometer from the vehicle.

Installation Procedure

Important:
Use care not to bend or distort the bracket that supports the yaw rate sensor/lateral accelerometer.





1. Install the yaw rate sensor/lateral accelerometer to the vehicle.

Notice:
Refer to Fastener Notice in Service Precautions.

2. Install the nuts retaining the yaw rate sensor/lateral accelerometer to the vehicle.
Tighten the nuts to 10 N.m (89 lb in).





3. Connect the electrical connector (3) to the yaw rate sensor/lateral accelerometer.
4. Install the carpet.
5. Install the passenger seat to the vehicle.