Weatherstrip Retainer - Roof Lift Off Panel Rear (Center)

Weatherstrip Retainer - Roof Lift Off Panel Rear (Center)

Removal Procedure




1. Remove the removable roof panel.




2. Remove the weatherstrip from the retainer.
3. Remove the screws attaching the retainer.
4. Remove the retainer.

Installation Procedure






Important: A minimum of 2 mm (0.08 in) of sealing foam must extend beyond the ends of the retainer to prevent water leaks.

1. Install foam sealing tape to a reusable retainer or peel protective cover from the foam tape on a new retainer.
2. Position the retainer to the roof.

Notice: Refer to Fastener Notice in Service Precautions.

Important: Stripped, broken, or improperly seated screws must be replaced or repaired to prevent water leaks.

3. Install the screws attaching the retainer.

Tighten the roof weatherstrip retainer screws to 3 N.m (27 lb in).




4. Install the weatherstrip.




5. Install the roof panel.