Tail/Backup Lamp Replacement (Europe)

REMOVAL PROCEDURE




1. Remove the screws retaining the tail/backup lamp assembly to the rear fascia.
2. Remove the lamp from the fascia to gain access to the tail and backup lamp sockets.
3. Remove the sockets from the lamp assembly. Rotate the sockets counterclockwise to disengage the locking tabs.
4. Remove the bulbs from the sockets, if replacing the bulbs.
5. Remove the lamp from the vehicle.

INSTALLATION PROCEDURE




1. Install the bulbs to the lamp sockets, if replacing the bulbs.
2. Install the sockets to the lamp assembly. Rotate the sockets clockwise to engage the locking tabs.
3. Position the tail/backup lamp assembly to the rear fascia.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the screws retaining the tail/backup lamp to the rear fascia.

Tighten
Tighten the tail/backup lamp retaining screws to 2 N.m (18 lb in).