Inflatable Restraint Steering Wheel Module Replacement

REMOVAL PROCEDURE




1. Disable the SIR system. Refer to: Air Bag(s) Arming and Disarming.
2. Remove the screws (4) retaining the inflatable restraint module (3) to the steering wheel.
3. Remove the inflatable restraint module (3) from the steering wheel.
4. Disconnect the Connector Position Assurance (CPA) (1) from the electrical connector (2) on the module coil.
5. Disconnect the electrical connector (2) from the back of the steering wheel module (3).
6. Disconnect the horn wiring harness (6) from the steering column.
7. Disconnect the ground wire (5) from the steering column.
8. Remove the steering wheel module (3) from the vehicle.
9. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping.

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service Precautions.




1. Install the inflatable restraint steering wheel module (3) and secure with the retaining screws (2).

Tighten
Tighten the screws to 6 N.m (54 lb in).




2. Connect the ground wire (5) to the steering column.
3. Connect the horn wiring harness (6) to the steering column.
4. Connect the electrical connector (2) to the back of the steering wheel module (3).
5. Install the CPA (1) to the electrical connector (2).
6. Install the inflatable restraint module (3) onto the steering wheel by pushing on both sides of the module until the retaining screws snap into place.
7. Enable the SIR system. Refer to: Air Bag(s) Arming and Disarming.