Electronic Column Lock Module - Assemble

Electronic Column Lock Module - Assemble - Off Vehicle (Telescoping Column)





1. Install the electric column lock (2) to the steering column tilt head assembly.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the 3 pan head tapping screws (1).
- Tighten the screws to 7 Nm (62 inch lbs.).





3. Slide the windshield wiper and washer switch assembly into the electric column lock until the clips engage.

Caution: Refer to SIR inflator module coil caution in Service Precautions.





4. Route the wire harness assembly along the steering column jacket assembly.
5. Connect the connector, if necessary.





6. Install the wire harness strap (2) to the steering column tilt head assembly (1).
7. Install the wire harness strap (2) onto the wire harness assembly.





8. Pop the wire harness assembly (1) into the wire harness strap (2).
9. Install the steering column tilt head housing.
10. Enable the inflatable restraint steering wheel module.