Compartment Lid Replacement - Rear

Compartment Lid Replacement - Rear

Removal Procedure




1. Open the rear compartment.
2. Apply tape to corners of panel and adjacent surfaces to help prevent paint damage.
3. Disconnect the electrical connector from the right quarter panel.
4. Remove the wiring harness grommet from the right quarter panel, using a small, flat-bladed tool.
5. Remove the wiring harness from the quarter panel.




6. Disconnect the electrical connector from the rear compartment lid lamps and the flasher fuse (1), if equipped.




7. With a grease pencil, mark the hinge which secures the rear compartment lid to the upper rear compartment.
8. Remove the nuts from the rear compartment hinges, with an assistant.
9. Remove the rear compartment lid from the vehicle, with an assistant.

Installation Procedure




1. Position the rear compartment lid to the hinges at the alignment marks, with an assistant.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the nuts to the rear compartment hinges, with an assistant.

Tighten the rear compartment lid hinge nuts to 25 N.m (18 lb ft).




3. Install the wiring harness to the quarter panel.
4. Install the wiring harness grommet to the right quarter panel, using a small, flat-bladed tool.
5. Connect the electrical connector to the right quarter panel.




6. Connect the electrical connector to the rear compartment lid lamps and the flasher fuse (1), if equipped.
7. Remove the protective coverings.
8. Close the rear compartment.