Inflatable Restraint Instrument Panel Module Replacement
REMOVAL PROCEDURECAUTION: Refer to SIR Inflator Module Handling And Storage Caution in Caution and Notices.
1. Disable the SIR system. Refer to Air Bag(s) Arming and Disarming.
2. Remove the instrument panel (I/P) upper trim pad.
3. Remove the connector position assurance (CPA) from the yellow 2-way wiring harness connector on the inflatable restraint I/P module.
4. Disconnect the harness connector from the I/P module.
5. Remove the I/P module mounting fasteners (3).
6. Remove the I/P module (1) from the cross-car beam (2).
7. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period.
INSTALLATION PROCEDURE
1. Install the I/P module (1) to the cross-car beam (2).
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the I/P module mounting fasteners (3).
Tighten
Tighten fasteners to 10 N.m (89 lb in).
3. Connect the yellow 2-way wiring harness connector to the I/P module.
4. Install the CPA to the wiring harness connector.
5. Install the I/P upper trim pad.
6. Enable the SIR system. Refer to Air Bag(s) Arming and Disarming.