81. Camshaft Position Actuator Magnet Installation

This article or image reflects the changes called out in TSB#05-06-01-027

Dated 09/16/05

For the following vehicles 2006 Buick Terraza,2006 Chevrolet Impala, Malibu, SS, Malibu Maxx, Monte Carlo, Uplander, 2006 Pontiac G6, Montana SV6 and 2006 Saturn Relay with 3.5 L or 3.9 L ( VIN's N, K, 1 & RPO's LZ4, LZE, And LZ9).


Notice: Use only a Torx Plus bit when removing or Installing Camshaft Position Actuator retention fasteners.


Camshaft Position Actuator Magnet Installation





1. Install the camshaft position actuator magnet and O-ring seal into the front cover.

Notice: Refer to Fastener Notice.

2. Install the camshaft position actuator magnet bolts.
Tighten the camshaft position actuator magnet bolts to 10 Nm (89 lb in).