Getrag 288 - Manual Transaxle

AXLE SEAL / REMOVAL
1. Raise vehicle on hoist.
2. Remove halfshaft(s) and intermediate shaft assembly if necessary.

Fig. 111 Axle Seal Removal:

3. Using suitable screwdriver, remove axle seal from transaxle case (Fig. 111). Use care not to damage seal bore.

Fig. 112 Axle Seal Installation:

INSTALLATION
1. Using Tool 8916, install new axle seal (Fig. 112). Drive seal until flush with case.
2. Install halfshaft(s) and intermediate shaft assembly if removed).
3. Check transaxle fluid level. (Refer to MANUAL TRANSMISSION/FLUID - STANDARD PROCEDURE)
4. Lower vehicle.