Getrag 288 - Manual Transaxle

GEAR SHIFT BOOT / REMOVAL

Fig. 141 Gearshift Knob Removal/Installation:

1. Pull up on gearshift knob with moderate force to remove from gearshift mechanism (Fig. 141) .

Fig. 142 Gearshift Boot Removal/Installation:

2. Remove shifter boot/bezel assembly from console by lifting up at mounting ring area (Fig. 142).

Fig. 142 Gearshift Boot Removal/Installation:

INSTALLATION
1. Position gearshift boot (Fig. 142) over the gearshift mechanism and engage tab on mount ring at front to opening in console. Apply hand pressure to engage bosses on mount ring of boot to console opening slots.

Fig. 141 Gearshift Knob Removal/Installation:

2. Position gearshift knob hole over the gearshift mechanism (Fig. 141) and align the shift pattern.
3. Strike knob with rubber mallet to engage knob to mechanism.
4. Verify that shift pattern is aligned properly.