Axle Seal

AXLE SEAL

REMOVAL
1. Remove axle shaft.





2. Insert a flat-blade pry tool (2) at outer edge of axle shaft seal (1).
3. Tap on the pry tool (2) with a small hammer and remove axle shaft seal (1).

INSTALLATION
1. Clean axle shaft seal bore of any excess sealant.
2. Align axle shaft seal with axle shaft seal bore.
3. Install axle seal on Seal Installer 6709 and Handle C-4171 and insert into axle shaft seal bore.
4. Tap seal into position until seated against transaxle case.
5. Install axle shaft.
6. Check transaxle fluid level and adjust as necessary.