Step 41 - 50

DISASSEMBLY

NOTE: If transaxle is being overhauled (clutch and/or seal replacement) or replaced, it is necessary to perform the PCM/TCM Quick Learn Procedure Testing and Inspection.

NOTE: This procedure does not include final drive (differential) disassembly.





41. Remove transfer shaft gear-to-shaft nut (3) and coned washer (2).




42. Using Gear Puller L-4407 A,(3) remove transfer shaft gear (2).




43. Remove transfer gear shim (select) (3).




44. Remove bearing cup retainer (2).




45. Remove transfer gear bearing cone using setup using Puller Set 5048 with jaws 5048-4 and button L-4539-2 (2).




46. Remove transfer shaft bearing cup from retainer (3) using Remover 6062- A (2).




47. Using Snap Ring Pliers 6051,(1) remove transfer shaft bearing snap ring (2).




48. Using the Remover/Installer 5049-A, (1) remove transfer shaft (2) from transaxle.




49. Slip bearing cup retainer (1) and oil baffle (4) off of shaft.




50. Using Bearing Splitter P-334,(3) press transfer shaft bearing cone (4) off of shaft (2).