Step 61 - 73

DISASSEMBLY

NOTE: If transaxle is being overhauled (clutch and/or seal replacement) or replaced, it is necessary to perform the PCM/TCM Quick Learn Procedure Testing and Inspection.

NOTE: This procedure does not include final drive (differential) disassembly.





61. Install Disk 6057 (1), compressor 5059 (2) and compressor bar 5058-3 (3).




62. Install low/reverse spring compressor.




63. Compress low/reverse piston return spring and remove snap ring (1).




64. Remove low/reverse spring compressor tool and low reverse piston return spring (1).




65. Using a suitable punch , drive out park guide bracket pivot shaft plug (3).




66. Using ordinary pliers, remove pivot shaft (3) and guide bracket assembly (2).




67. Inspect guide bracket components for excessive wear and replace Anti-ratching spring (1), guide bracket (2), Split sleeve (3), spacer (4), pawl (5) and stepped spacer (6) if necessary.




NOTE: The Low/Reverse Clutch Piston has bonded seals which are not individually serviceable. Seal replacement requires replacement of the piston assembly.

68. Remove low/reverse clutch piston (1).




69. Remove low/reverse piston retainer-to-case screws (3).




70. Remove low/reverse piston retainer (1).




71. Remove low/reverse piston retainer-to-case gasket (2), gasket holes must line up (1).




72. Using a hammer (2) and suitable drift (3), drive out inner output bearing cup (1).




73. Using Remover 6062 (1), remove outer output bearing cup.