Bulb Application - Interior Lamps

BULB APPLICATION

CAUTION: Do not use bulbs that have a higher candle power than the bulb listed in the chart below. Damage to the lamp can result.

When illumination goes out in the Electronic Instrument Cluster (EIC) the complete button module must be replaced. The Mechanical Instrument Cluster (MIC) uses PC194 bulbs for illumination.

When changing lamp bulbs check the socket for corrosion. If corrosion is present, clean it with a wire brush and coat the inside of the socket lightly with Mopar Multi-purpose grease or equivalent.

INTERIOR LAMPS
A/C Heater Control 158
Ash Receiver 161
Cigar Lighter 161
Headlamp Switch 158
Heater Control 158
Instrument Cluster PC194
Radio ASC

INDICATOR LAMPS
Airbag High Line PC194
Airbag Low Line PC74
Antilock Brake PC74
Battery Voltage PC194
Brake Warning PC194
Check Engine PC74
Engine Oil Pressure PC74
Four Wheel Drive PC194
High Beam PC194
Low Fuel PC194
Low Washer Fluid PC74
Maintenance Required PC74
Message Center PC194
Seat Belt PC74
Turn Signal PC194
Upshift PC74

NON-DIMMING LAMPS
Dome 1004
Glove Compartment 1891
Vanity Mirror Lamp(2) P/N 6501966