Rear Wiper Relay Replacement

REMOVAL
1. Disconnect and isolate the battery negative cable.

Fig.15 Power Distribution Center - Typical:

2. Remove the cover from the Power Distribution Center (PDC).
3. See the fuse and relay layout label affixed to the underside of the PDC cover for rear wiper relay identification and location.
4. Remove the rear wiper relay by grasping it firmly and pulling it straight out from the receptacle in the PDC.

INSTALLATION
1. See the fuse and relay layout label affixed to the underside of the PDC cover for the proper rear wiper relay location.
2. Position the rear wiper relay in the proper receptacle in the PDC.
3. Align the rear wiper relay terminals with the terminal cavities in the PDC receptacle.
4. Push firmly and evenly on the top of the rear wiper relay until the terminals are fully seated in the terminal cavities in the PDC receptacle.
5. Reinstall the cover onto the PDC.