Incomplete Latch Release - Full Open Switch Failure

Test 1:

Tests 2 - 6:

Tests 7 - 8:

SYMPTOM
INCOMPLETE LATCH RELEASE - FULL OPEN SWITCH FAILURE

WHEN MONITORED
Whenever the power sliding door is operating in the closing direction.

SET CONDITION
The release operation had stalled or the current was exceeded before the full open switch had changed state during the release. This code will set only in power closing operation.

POSSIBLE CAUSES
- DTC present
- Full open switch ground open
- Sticking cables or latch
- Full open switch wire open
- Full open switch wire short to ground
- Latch assembly - hold open release
- Power sliding door module - full open switch
- Full open switch