Incomplete Power Open - Excessive Hall Effect Signal

Test 1:

Tests 2 - 7:

Tests 8 - 10:

SYMPTOM
INCOMPLETE POWER OPEN - EXCESSIVE HALL EFFECT SIGNAL

WHEN MONITORED
Anytime the power sliding door is in the opening cycle.

SET CONDITION
If the PSD Module detects an excessive hall effect signal or a missing hall effect signal for longer than 300 ms during an opening operation, this code will set. This is a redundant safety feature in the software and will set if the obstacle detection feature becomes inoperative due to a hall effect sensor or connector malfunction.

POSSIBLE CAUSES
- DTC present
- Power sliding door module - hall effect open
- Lower drive unit
- Binding door
- Hall effect ground circuit open
- Door motor hall effect supply wire open
- Door motor hall effect supply wire short to ground
- Door motor hall effect signal wire open
- Door motor hall effect signal wire short to ground
- Door motor assembly