Powertrain Verification Test - Ver 1

NGC POWERTRAIN VERIFICATION TEST VER - 1

Note: 1. If this vehicle is equipped with an Electron Throttle Control system, and the APP Sensors, PCM, or Throttle Body Assembly have been replaced, use a scan tool to perform the ETC RELEARN function.

Note: 2. After completing the Powertrain Verification Test the Transmission Verification Test must be performed.

Note: 3. If the PCM has been replaced and the correct VIN and mileage have not been programmed, a DTC will set in the ABS Module, Airbag Module and the SKIM.

Note: 4. If the vehicle is equipped with a Sentry Key Immobilizer System, Secret Key data must be updated.

5. Inspect the vehicle to ensure that all components related to the repair are properly installed and connected.
6. Inspect the engine oil for fuel contamination. Replace the oil and filter as necessary.
7. Attempt to start the engine.
8. If the No Start condition is still present, perform the diagnostic testing as necessary.
9. Run the engine for one warm-up cycle to verify operation.
10. With the scan tool, confirm that no DTCs or Secondary Indicators are present and that all components are functioning properly.
Are any DTCs or symptoms remaining?
Yes>> Check for any related Technical Service Bulletins and/or refer to the appropriate Diagnostic Procedure.
No>> Repair is complete.