Rear Blower Motor

REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the rear HVAC housing. Refer to: Heating and Air Conditioning, Service and Repair, HVAC Housing Removal and Installation, Rear HVAC Housing, Rear HVAC Housing Removal and Installation




3. Disconnect the rear HVAC wire harness connector (1) from the rear blower motor (2).
4. Remove the three screws (3) that secure the rear blower motor to the rear air inlet housing (4).
5. Remove the rear blower motor from the rear air inlet housing.

INSTALLATION




1. Position the rear blower motor (2) into the rear air inlet housing (4).
2. Install the three screws (3) that secure the rear blower motor to the rear air inlet housing. Tighten the screws to 2.2 Nm (20 in. lbs.).
3. Connect the rear HVAC wire harness connector (1) to the rear blower motor.
4. Install the rear HVAC housing. Refer to: Heating and Air Conditioning, Service and Repair, HVAC Housing Removal and Installation, Rear HVAC Housing, Rear HVAC Housing Removal and Installation

5. Reconnect the negative battery cable.