Sun Shade: Service and Repair

SUNSHADE

REMOVAL





1. Remove the water channel.
2. Cycle sunroof motor (9) to the open position.
3. Move sunshade (5) towards the closed position stopping three to four inches from the closed position.
4. Depress the spring feet clips (1) in the cross car direction on one side of the sunshade by applying a side-load to the shade while pulling up at the front centerline of the sunshade. This will cause one spring feet clip (1) to pop out of the track.





5. Remove the other front foot by rotating the shade (1) out and the foot resting on the top of the sunroof frame (2).
6. Pull the shade farther forward in the vehicle and repeat the previous step to remove the rear spring feet.
7. Remove the sunshade (2).

INSTALLATION





1. Place one side of the sunshade (1) spring feet clips into the top track U-frame (2).





2. Depress the both releasing clips (1) on the other side to allow them to go into the top track of the U-frame (2).
3. Move sunshade to the open position.
4. Verify that the sunshade moves back and forth properly.
5. Cycle sunroof towards the closed position.
6. Position the sunshade so that the handle is in the center of the opening.
7. Install the water channel.