Channel-Glass

CHANNEL-GLASS

REMOVAL




1. Raise the glass to the full up position.
2. Remove the watershield. Refer to Front Door Panel.
3. Remove the nuts (2) and disconnect the electrical connector (3), if equipped.
4. Remove the side view mirror (1).




5. Separate the inner belt molding from the mounting flange from the rear to the front.
6. Insert special tool #9093 (2) between the outer belt molding (1) and glass at the rear.
7. Push down on outer belt molding (1) and rotate upper part of tool (2) outward from vehicle then lift up on molding (1) to disengage from locking tabs (3) working from back to front.

NOTE: Typical outer belt molding design shown.




8. Remove the nut (2) and bolt (3) and remove the rear glass run channel (1).
9. Remove the bolts (6 & 5) and remove the front glass run channel (4).

INSTALLATION




1. Install the front glass run channel (4) and install the bolts (6 & 5). Tighten the bolts to 8 N.m (70 in.lbs.).
2. Install the rear glass run channel and install the nut and bolt.
3. Tighten the fasteners to 8 N.m (70 in.lbs.).
4. Position the inner and outer belt molding onto the door and seat fully.




5. Install the side view mirror.
6. Install the nuts and connect the electrical connector.
7. Install the watershield.