Winch Relay Pack
RELAY PACKREMOVAL
1. Disconnect and isolate battery negative cable (3).
2. Remove the winch assembly (2).
3. Remove the nut and disconnect the red battery positive cable (1).
NOTE: Relay #4 shown, all others similar.
4. Remove the control wire nuts (1) and disconnect the control wires (2) from each relay.
INSTALLATION
NOTE: Relay #4 shown, all others similar.
1. Install the control wires (2) to all the relays and install the nuts (1).
2. Tighten the nuts to 3 N.m (25 in.lbs.).
3. Install the red battery positive cable (1) and install the switch wire.
4. Install the nut and tighten to 10 N.m (85 in.lbs.).
5. Install the relay pack cover (1) and install the three screws (2).
6. Install the winch assembly (2).
7. Connect the battery negative cable (3) and verify winch operation.