Carpet: Service and Repair

CARPETS AND FLOOR MATS

NOTE: Carpet for Quad Cab model shown. Regular cab similar.

REMOVAL




1. Remove the front seats.
2. If equipped, remove the floor console.
3. If equipped, remove the three bolts (1) that secure the rear storage compartment (2) to the floor panel (3) and remove the storage compartment from the rear trim panel (4).




4. On Quad Cab models, remove the rear seats (1).
5. On Quad Cab models, remove the rear cup holder (2) using a trim stick C-4755 or equivalent.




6. Remove the lower B-pillar trim panels, Refer to Trim Panel.
7. On Quad Cab models, remove the bolt that secures the lower seat belt anchor to the floor panel near the B-pillars.
8. Remove the retaining screw (1) that secures the jack assembly (2) to the floor panel (3) and remove the jack assembly.
9. Remove the two bolts (4) that secure the jack assembly to the floor panel.




10. For trucks equipped with a scissor type jack, remove the bolts (1) and remove the jack (2).




11. Remove the screws and remove the load floor storage strap snaps (1).




12. On Quad Cab models, remove the eleven pushpin fasteners (1) that secure the rear of the carpet (2) to the floor panel (3).
13. Remove the carpet from the vehicle.

INSTALLATION




1. Position the carpet (2) into the vehicle.
2. On Quad Cab models, install the eleven push-pin fasteners (1) that secure the carpet to the floor panel (3).




3. Install the load floor storage snaps and screws (1).




4. On trucks equipped with a scissor jack, install the jack and install the bolts (1).




5. Install the two bolts (4) that secure the jack assembly (2) to the floor panel (3).
6. Position the jack assembly onto the two bolts and install the retaining screw (1). Tighten the screw securely.
7. On Quad Cab models, install the bolt that secures the lower seat belt anchors the floor panel near the B-pillars. Tighten the bolt to 40 N.m (30 ft.lbs.).
8. Install the lower B-pillar trim panels.




9. On Quad Cab models, install the rear seat (1).
10. On Quad Cab models, install the rear cup holder (2).




11. If equipped, position the rear storage compartment (2) onto the rear cab trim panel (4) and install the three bolts (1). Tighten the bolts to 6 N.m (55 in.lbs.).
12. If equipped, install the floor console.
13. Install the front seats.