D-Pillar Trim

PANEL-D PILLAR TRIM

REMOVAL




1. Move the third row seat cushion to its storage position, but leave the third row seat back in its upright position for easiest access to the seat belt lower anchor (2) on the quarter inner panel (3).
2. Remove the screw (1) that secures the lower anchor to the tapping plate on the quarter inner panel.




3. Using a trim stick C-4755 or equivalent, remove the upper rear headliner trim.
4. Remove the screw (1).
5. Using a trim stick C-4755 or equivalent, separate the trim (2) and retaining clips and anchor (3).

INSTALLATION




1. Position the shoulder belt through the slot in the trim.
2. Position the trim (2) in place on the D-pillar and anchor (3).
3. Seat the retaining clips fully and install the screw (1).
4. Position the rear header trim in place and seat the retaining clips fully.




5. Position the seat belt lower anchor (2) to the tapping plate (3) on the quarter inner panel.
6. Install the screw (1) that secures the lower anchor to the tapping plate and tighten the to 39 N.m (29 ft.lbs.).