Rear
SEAT BELT AND RETRACTORREAR - WAGON
REMOVAL
1. Remove the lower seat belt anchor (2) bolt (3).
2. Remove the quarter trim panel.
3. Remove the one rear seat belt retractor (4) retaining nut (2).
INSTALLATION
1. Place the one rear seat belt retractor (4) so that the indexing tab is in its slot.
2. Install the retaining nut (2). Torque nut to 34 N.m (25 ft. lbs.).
3. Install the quarter trim panel.
4. Install the lower seat belt anchor (2) bolt (3). Torque bolt to 32 N.m (24 ft. lbs.).
REAR CENTER - WAGON
REMOVAL
1. Remove the left seat back trim cover (60% portion of the rear folding seats).
2. Disconnect the rear seat back latching cable from seat frame.
NOTE: If the seat back is not fully latched, the center seat belt will not release from the retractor.
3. Remove the one bolt (2) holding the rear center seat belt retractor.
INSTALLATION
1. Position the rear center retractor into position in the seat back.
2. Install the one bolt (2) holding the rear center seat belt retractor. Torque nut to 34 N.m (25 ft. lbs.).
3. Install the left seat back trim cover (60% portion of the rear folding seats).