Installation

INSTALLATION




Figure 1 Valve Body Removal/Installation


1 - VALVE BODY


NOTE: If valve body assembly is being replaced or reconditioned, the "Quick-Learn" procedure must be performed.

1. Install valve body assembly to transaxle (Figure 1).




Figure 2 Valve Body Attaching Bolts






2. Install and torque valve body-to-transaxle case bolts to 12 Nm (105 in. lbs.).




Figure 3 Oil Filter






3. Install transaxle oil filter (Figure 3). Inspect the O-ring and replace if necessary.




Figure 4 Oil Pan






4. Ensure the transaxle oil pan and transaxle case sealing surfaces are clean and dry. Install an 1/8" bead of Mopar(R) Silicone Rubber Adhesive Sealant to the oil pan and install.




Figure 5 Oil Pan Bolts


1 - OIL PAN BOLTS (USE RTV UNDER BOLT HEADS)

5. Torque oil pan-to-transaxle case bolts to 19 Nm (165 in. lbs.).
6. Lower vehicle.
7. Connect transmission range sensor connector.
8. Install manual valve lever to manual shaft.
9. Install gearshift cable to manual valve lever.
10. Connect battery negative cable.
11. Fill transaxle with Mopar(R) ATF +4 Transmission fluid.