Installation

INSTALLATION
1. Position quarter trim panel on vehicle.

2. Pass first row seat belt through slot in trim panel.

3. Pass second row seat belt through access hole in trim panel on long wheel base vehicle.

4. Connect wire connector into speaker on LWB with rear air conditioning.

5. Align locating pins on backside of trim panel to mating holes in inner quarter panel.

6. Engage hidden clips attaching front of quarter trim to quarter panel rearward of sliding door opening and at locators.

7. Install screws attaching rear edge of quarter trim to attaching bracket.

8. Install screws attaching quarter trim to inner quarter panel in bolster area.

9. Install second row seat belt anchor on long wheel base vehicle. Tighten all seat belt bolts to 39 Nm (29 ft. lbs.) torque.

10. Install first row seat belt anchor.

11. Install D-pillar trim panel.

12. Install C-pillar trim panel.

13. Install quarter trim bolster.

14. Install sliding door sill trim panel.

15. Install second row seat, if equipped.

16. Install first row seat.

17. Connect the battery negative cable.