Power Seat Fore Aft Motor - Installation

INSTALLATION

WARNING: Disable the airbag system before attempting any component diagnosis or service of the front seats, when equipped with front seat air bags. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may result in accidental airbag deployment and possible serious or fatal injury.

CAUTION: Seat track side to side timing may be off if the fore aft motor was completely inoperative prior to removal. In the event the track timing is in question, proceed to STEP 1 for track timing procedure. If track timing is not in question proceed to STEP 2.

1. Using the square drive end of the old flex drive cable and a variable speed drill motor, drive the seat track screw drive assemblies reward until they reach the rear stops.
a. Clamp one end of the old cable into the drill motor chuck.
b. Put the other cable end into the seat track screw drive cable slot and slowly drive the seat track assembly reward until it reaches the rear stops. Take care not to bind the cable when the drive reaches the stop.
c. Repeat this procedure for the other seat track.




2. Install the short flex drive cable (2) into the seat frame assembly (4). Ensure the square cable end is properly aligned and fully inserted into the square drive slot of the screw drive assembly.
3. Install the fore/aft motor (3) ensuring the square cable end is properly aligned and fully inserted into the square drive slot of the motor.
4. Install the motor retaining screws (1). Tighten the screws to 5 Nm (45 in. lbs.).




5. Install the flex drive cable.
a. Install the flex drive cable into the seat frame assembly (2). Ensure the square cable end is properly aligned and fully inserted into the square drive slot of the screw drive assembly.
b. Install the flex drive cable into the fore/aft motor (1). Ensure the square cable end is properly aligned and fully inserted into the square drive slot of the motor assembly (3).




6. Position the flex drive cable cover (2) onto the seat track assembly (4). Ensure the cover slots are properly aligned and fully inserted onto the mounting tabs (3).
7. Pivot the cable cover towards the cable and onto the fore/aft motor (5).
8. Secure the cover to the motor with the retaining strap (1).
9. Connect the fore/aft motor electrical connector.
10. Install the power seat,Seat - Installation.
11. Verify proper power seat operation.