Front

INSTALLATION





WARNING: Before proceeding with the following repair procedure, review all warnings and cautions Service Precautions.

1. Install the seat bottom to the seat back frame.
2. Install the two seat frame bolts to the left and right side of the seat and tighten to 47.5 Nm (35 ft. lbs.)




3. Install the recliner cable to the left and right side of the seat if equipped, passenger side only.
4. Install the electrical harness to the seat bottom.
5. Install the right and left seat tracks to the seat frame and tighten the nuts to 27.5 Nm (20 ft. lbs.).




CAUTION: The Heated Seat Module mounting tab can be damaged during module removal and installation. Use care to properly align tab to prevent binding that could result in tab breakage.

6. Install the heated seat module (3) into the vehicle.
7. Position the retaining tab (2) with the mounting hole in the seat pan (1). Firmly apply even pressure to the module (3) until the mounting tab is fully seated.
8. Connect the wire harness connector (4) to the heated seat module (3).




9. Install the seat position sensor.
10. Install the two screws to the side of the outer seat trim.




11. Install the two screws to the rear of the outer seat trim.
12. Install the recliner handle.




13. Install the electrical connectors for both the heated seat back and seat elements.




14. Install the electrical harness connectors to the OCS mounting plate.




15. Install the occupant classification module and connect the electrical connectors if equipped, passenger side only, Occupant Restraint Controller - Installation.




16. Install the seat weight sensors if equipped, passenger seat only, Installation.
17. Install the passenger or drivers front seat, Seat - Installation.