Gasoline Engine

GASOLINE ENGINE





1. Position the washer reservoir (1) into the right side of the engine compartment.
2. Align and insert the two mounting tabs at the bottom of the reservoir into the two slots (6) at the bottom of the radiator shroud.
3. Place both hands on the top of the washer reservoir and push the unit downward far enough for the locking feature on the washer reservoir to snap into the depression in the radiator shroud.
4. Install and tighten the two screws (2) that secure the mounting brackets at the top of the reservoir to the mounting provisions at the top of the radiator shroud. Tighten the screws to 7 Nm (60 in. lbs.).
5. Reconnect the right headlamp and dash wire harness connector to the washer pump/motor unit connector receptacle (7).
6. Reconnect the right headlamp and dash wire harness connector to the washer fluid level switch connector receptacle (5).
7. Reconnect the reservoir washer hose (4) to the barbed nipple of the inline fitting at the engine compartment washer hose in the right headlamp and dash wire harness.
8. Reconnect the coolant overflow hose (3) to the nipple on the radiator filler neck. Coolant Recovery Container - Installation .
9. Refill the washer reservoir with the washer fluid drained from the reservoir during the removal procedure.
10. Reconnect the battery negative cable.
11. Check and adjust the coolant level in the coolant overflow bottle as necessary. Service and Repair .