Carpet - Installation

INSTALLATION

NOTE: Carpet for Quad Cab model shown. Regular cab similar.





1. Position the carpet (2) into the vehicle.
2. On Quad Cab models, install the eleven push-pin fasteners (1) that secure the carpet to the floor panel (3).




3. Install the load floor storage snaps and screws (1).




4. On trucks equipped with a scissor jack, install the jack and install the bolts (1).




5. Install the two bolts (4) that secure the jack assembly (2) to the floor panel (3).
6. Position the jack assembly onto the two bolts and install the retaining screw (1). Tighten the screw securely.
7. On Quad Cab models, install the bolt that secures the lower seat belt anchors the floor panel near the B-pillars Seat Belt and Retractor - Installation . Tighten the bolt to 40 Nm (30 ft. lbs.).
8. Install the lower B-pillar trim panels B-Pillar Trim .




9. On Quad Cab models, install the rear seat (1) Seat - Installation .
10. On Quad Cab models, install the rear cup holder (2).




11. If equipped, position the rear storage compartment (2) onto the rear cab trim panel (4) and install the three bolts (1). Tighten the bolts to 6 Nm (55 in. lbs.).
12. If equipped, install the floor console Floor Console - Installation .
13. Install the front seats Seat - Installation .