B1889

B1889-POWER LIFTGATE PINCH SENSOR 1 CIRCUIT HIGH





For a complete wiring diagram, refer to the Wiring Information Electrical Diagrams.

- When Monitored:
Whenever the Power Liftgate Module is awake.

- Set Condition:
The power liftgate module has detected the left pinch sensor circuit voltage is above 4.6 volts for over 10 seconds.





1. DTC PRESENT
1. With the scan tool, record the DTCs and any liftgate inhibitors.
2. Erase the DTCs
3. Turn the ignition off, wait 10 seconds, then turn the ignition on.
4. Operate the liftgate several times.
5. With the scan tool, read the DTCs.

Does the scan tool display B1889-POWER LIFTGATE PINCH SENSOR 1 CIRCUIT HIGH?

Yes

- Go To 2

No

- Using the wiring diagram/schematic as a guide, inspect the wiring and connectors for an intermittent condition.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. (Q901) LOGIC GROUND OPEN




1. Turn the ignition off.
2. Remove the Liftgate trim panel.
3. Disconnect the Liftgate Left Pinch Sensor connector.
4. Measure the resistance between ground and the (Q901) Logic Ground circuit in the Liftgate Left Pinch Sensor connector.

Is the resistance below 5.0 Ohms?

Yes

- Go To 3

No

- Repair the (Q901) Logic Ground circuit for an open.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

3. (Q75) LEFT PINCH SENSOR SIGNAL CIRCUIT OPEN




1. Turn the ignition on.
2. Measure the voltage between the (Q901) Logic Ground circuit and the (Q75 ) Left Pinch Sensor Signal circuit in the Left Pinch Sensor connector.

Is the voltage below 5.3 volts?

Yes

- Go To 4

No

- Go To 5

4. (Q75) LEFT PINCH SENSOR SIGNAL WIRE OPEN




1. Turn the ignition off.
2. Disconnect the Power Liftgate Module C2 connector.
3. Measure the resistance of the Left Pinch Sensor Signal circuit between the Power Liftgate Module C2 connector and the Left Pinch Sensor connector.

Is the resistance below 5.0 Ohms?

Yes

- Replace the Power Liftgate Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Repair the (Q75) Left Pinch Sensor Signal wire for an open.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

5. (Q75) LEFT PINCH SENSOR SIGNAL SHORTED TO VOLTAGE




1. Measure the voltage between the (Q901) Logic Ground circuit and the (Q75 ) Left Pinch Sensor Signal circuit in the Left Pinch Sensor connector.

Is the voltage above 5.2 volts?

No

- Replace the Left Pinch Sensor.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

Yes

- Repair the Left Pinch Sensor Signal wire for a short to battery
- Perform the BODY VERIFICATION TEST. Body Verification Test.