U1199

U1199-LOST HOOD AJAR SWITCH VOLTAGE MESSAGE





For a complete wiring diagram, refer to the Wiring Information Electrical Diagrams.

Theory of Operation

The Hood Switch 1 signal is a direct input to the Front Control Module (FCM). The FCM sends the Powertrain Control Module (PCM) the Hood Switch 1 signal over the CAN C bus.

- When Monitored:
Ignition on.

- Set Condition:
The PCM doesn't receive the Hood Switch 1 signal over the CAN C bus from the FCM. The circuit is continuously monitored. One trip fault.





WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Pre-Diagnostic Troubleshooting Procedure.

1. ACTIVE DTC
1. Ignition on.
2. With the scan tool, select View DTCs.

Is the DTC Active at this time?

Yes

- Go To 2

No

- Perform the INTERMITTENT CONDITION diagnostic procedure. Intermittent Condition Test.

2. U0141-LOST COMMUNICATION WITH FRONT CONTROL MODULE ALSO ACTIVE
1. With the scan tool read DTCs.

Is the U0141-NO BUS MESSAGE RECEIVED FROM THE FCM also set?

Yes

- Follow the diagnostics for U0141-LOST COMMUNICATION WITH FRONT CONTROL MODULE U0141.

No

- Replace and program the Powertrain Control Module.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test.