Installation - Without Accelerator Pedal Position Sensor

WITHOUT ACCELERATOR PEDAL POSITION SENSOR (APPS)





The accelerator cable is connected to the upper part of the accelerator pedal arm by a plastic retainer (clip) (7). This plastic retainer snaps into the top of the accelerator pedal arm.

1. Place accelerator pedal assembly (4) over two mounting studs (3).
2. Install and tighten two mounting nuts (5). Refer to Torque Specifications.
3. Slide throttle cable into opening slot (6) in top of pedal arm.
4. Push plastic cable retainer (clip) (7) into accelerator pedal arm opening until it snaps into place.
5. Before starting engine, operate accelerator pedal to check for any binding.