Tilt Motor

REMOVAL






WARNING: Disable the airbag system before attempting any component diagnosis or service of the front seats, when equipped with front seat air bags. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may result in accidental airbag deployment and possible serious or fatal injury.

1. Disconnect and isolate the battery negative cable.
2. Remove the inoperative front seat assembly, Seat - Removal.
3. Disconnect the front tilt motor electrical connector.
4. Remove the front tilt motor gearbox spindle (3) retaining screw (2).
5. Remove the motor retaining screws (4).
6. Remove the front tilt motor and gearbox assembly (1) from the seat track.