Front Air Inlet Housing

HOUSING-AIR INLET

NOTE: The air inlet housing must be removed from HVAC housing and disassembled for service of the recirculation-air door.





1. Position the air inlet housing (2) to the top of the HVAC housing (3) and engage the two tab-and-slot type retainers (4) located on the right side of the housings.
2. Tip the left side of the air inlet housing downward until it is properly seated on the HVAC housing.
3. Install the screw (1) that secures the air inlet housing to the HVAC housing. Tighten the screw to 2.2 Nm (20 in. lbs.).





4. Install the two screws (4) that secure the left side of the air inlet housing (2) to the HVAC housing (3). Tighten the screw to 2.2 Nm (20 in. lbs.).
5. Connect the wire harness connector to the recirculation door actuator (1).
6. Install the HVAC housing assembly HVAC Housing - Installation.