Third Row

THIRD ROW

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.





1. Check to be certain that the molded retractor shield (2) is properly installed in the retractor mounting hole (1) of the inner D-pillar, and that it is in good condition.





2. Position the third row seat belt and retractor to the D-pillar (2) as a unit.
3. Install and tighten the screw (3) that secures the retractor bracket to the upper D-pillar. Tighten the screw to 54 Nm (40 ft. lbs.).
4. Position the seat belt turning loop (1) to the upper D-pillar.
5. Install and tighten the screw that secures the turning loop to the D-pillar. Tighten the screw to 54 Nm (40 ft. lbs.).
6. Route the seat belt through the access hole in the upper D-pillar trim panel.
7. Reinstall the trim onto the inside of the upper D-pillar. D-Pillar Trim Panel - Installation.
8. Engage the third row seat belt anchor latch plate to the lower anchor buckle (4).