Brake Master Cylinder Reservoir - Installation

INSTALLATION





1. Install the fluid level sensor (4) into the reservoir (1).

CAUTION: Do not use tools to install the o-rings. Tools may cut, or tear the o-rings. Install the o-rings using finger pressure only.

2. Lubricate new o-rings with clean brake fluid.

CAUTION: Do not rock the reservoir during installation.

3. Start reservoir in o-rings then press the reservoir straight down to seat the reservoir into the cylinder o-rings.
4. Install the reservoir retaining screw (3).
5. Install the wire connector (4) to the brake fluid level sensor (3).
6. Remove brake pedal prop rod.
7. Fill master cylinder.