Front Cable

FRONT









1. Install the front cable end (1) into the brake lever assembly (3).





2. Install the front cable housing (3) to the bracket (1).





3. Route the cable (1) along and through the floor, and seat the grommet so that it is sealed.
4. Install the front parking brake cable to body clips and retaining nuts (2) to the studs and tighten to 8 Nm (71 in. lb.).
5. Install the wiring harness on the body retaining studs (2) as necessary.
6. Raise and support the vehicle Maintenance.





7. Connect the right rear and left rear parking brake cables (2, 5) to the equalizer (1).
8. Install the cable to body clip and retaining nut (3) to the stud and tighten to 8 Nm (71 in. lb.).
9. Remove the supports and lower the vehicle.
10. Remove the lockout of the parking brake assembly Service and Repair.
11. Install the left footwell load floor Load Floor - Installation
12. Install the right rear seat Service and Repair
13. Install the steering column opening cover Steering Column Opening Cover - Installation.