Rear Output Shaft Seal - Installation

INSTALLATION

Special Tools:






NOTE: Lubricate all seals with MOPAR(R) ATF+4 prior to installation.





1. Install a new rear output shaft seal into the rear cover with Driver Handle and inverted Installer.





2. Install the rear output shaft flange onto the output shaft.





3. Using Holder (1), install the rear companion flange (2) nut. Tighten the nut to 122-176 Nm (90-130 ft.lbs.).
4. Install the rear propeller shaft. Drive Shaft - Installation.
5. Check the transfer case fluid level. Service and Repair Correct as necessary.