Third Row, Stow-n-Go

INSTALLATION






NOTE: On all leather trimmed seats, back cover can be removed from the back foam pad. On cloth trimmed seats, the back cover does not separate from the foam pad.

1. If required, install the seat back cover to the foam by engaging the locking strips to the keepers.
2. Install the seat back cover and foam over the headrest and onto the seat back frame. Make sure the headrest release strap is properly fed through it's opening.
3. For 60% seats, install the center headrest sleeves (2) by aligning and pushing down until the retaining tabs are fully seated.





4. Pull the seat cover into position and zip the sides closed.
5. Make sure the seat back cover is properly tucked.
6. Position the side shield (1). Make sure the recliner straps are routed into the side shield. Repeat on the opposite side.





7. Install the fastener (2) into the front of the side shield (1). Tighten the fastener securely. Repeat on the opposite side.





8. Position the front of the rear shield (1) and roll it downward. Make sure the rear stow and go strap (2) is fed through the opening in the shield.
9. Install the fasteners (3) securing the rear shield (1). Tighten the fasteners securely.





10. Position the seat in the fold flat position.
11. Disengage the J-clips (1) from each other.





12. Fold the headrest into the downward position.
13. Tuck the seat back cover under the headrest and detach the hook and loop strips (1) from each other.





14. Feed the headrest release strap (1) through the release strap bezel (2).
15. Position the release strap bezel (2) to the rear of the seat back. Once positioned, push in to install.





16. For 60% seat, install the center headrest (1) by depressing the button on the sleeves and pushing straight down.